Symptom :
Fill nozzle does not engage with pipette
Hint :
Additional information :
Note the applicable nozzle configuration, advised is to use the latest nozzle configuration
Led status of the four stages for the previous version.
Current nozzle unit adjustment
FAQ 30009
Aspiration, vacuum and liquid flow FAQ index
Very small air bubbles enter the pipette during aspiration (FAQ)
One air bubble in the pipette (FAQ)
Air bubbles entering the pipette during aspiration (FAQ)
One air bubble about 5mm under meniscus (FAQ)
Liquid flowing back to the rinse bottle or cubitainer (FAQ)
Waste pump slows down and stops after 1 minute (FAQ)
First pipette is not washed sufficiently (FAQ)
Liquid dripping from needle (FAQ)
Rinse solution is not primed through system (FAQ)
Position error E18 (FAQ)
Fill-nozzle not functioning (FAQ)
Container "empty" not detected on Waste container (FAQ)
Pipette looks like a zebra crossing (FAQ)
Sample is not or only partially aspirated (FAQ)
Waste pump tube not functioning correctly (FAQ)
Zebra striping(FAQ)
ESR unit does not accept any ESR from LAB host computer (FAQ)
Carousel moves three position steps (FAQ)
ow to handle samples if the barcode is not read correct ?