Carousel moves three position steps (FAQ)

Carousel moves three position steps (FAQ)

Symptom :

Carousel moves three position steps.

Hint :

Caused by a faulty sensor or cable

Check the START/STOP sensor from the carousel drive motor.
Faulty connection cable
Faulty sensor.

Additional information :

Applicable for:

Starrsed RS
Interrliner
Starrsed TL

FAQ 30051

See Also

Aspiration, vacuum and liquid flow FAQ index

Very small air bubbles enter the pipette during aspiration (FAQ)

One air bubble in the pipette (FAQ)

Air bubbles entering the pipette during aspiration (FAQ)

One air bubble about 5mm under meniscus (FAQ)

Liquid flowing back to the rinse bottle or cubitainer (FAQ)

Waste pump slows down and stops after 1 minute (FAQ)

First pipette is not washed sufficiently (FAQ)

Liquid dripping from needle (FAQ)

Rinse solution is not primed through system (FAQ)

Position error E18 (FAQ)

Fill nozzle does not engage with pipette (FAQ)

Fill-nozzle not functioning (FAQ)

Container "empty" not detected on Waste container (FAQ)

Pipette looks like a zebra crossing (FAQ)

Sample is not or only partially aspirated (FAQ)

Waste pump tube not functioning correctly (FAQ)

Zebra striping(FAQ)

ESR unit does not accept any ESR from LAB host computer (FAQ)

ow to handle samples if the barcode is not read correct ?