Contents

 
 Starrsed FAQ Section
Collapse General FAQ section
   Collapse ESR FAQ
      Expand Dilution FAQ
      Collapse Aspiration, vacuum and liquid flow FAQ index
          Very small air bubbles enter the pipette during aspiration (FAQ)
          One air bubble in the pipette (FAQ)
          Air bubbles entering the pipette during aspiration (FAQ)
          One air bubble about 5mm under meniscus (FAQ)
          Liquid flowing back to the rinse container (FAQ)
          Waste pump slows down and stops after 1 minute (FAQ)
          First pipette is not washed sufficiently (FAQ)
          Liquid dripping from needle (FAQ)
          Rinse solution is not primed through system (FAQ)
          Position error E18 (FAQ)
          Fill nozzle does not engage with pipette (FAQ)
          Fill-nozzle not functioning (FAQ)
          Container "empty" not detected on Waste container (FAQ)
          Pipette looks like a zebra crossing (FAQ)
          Sample is not or only partially aspirated (FAQ)
          Waste pump tube not functioning correctly (FAQ)
          Zebra striping(FAQ)
          ESR unit does not accept any ESR from LAB host computer (FAQ)
      Expand Measurement and results FAQ
   Expand Cleaning and drying
    Carousel moves three position steps (FAQ)
   Expand Quality control
   Expand Software and hardware FAQ
   Expand Reagents
   Expand Error lists
    Extended Error explanation (Starrsed Software)
Expand Instrument specific FAQ
Expand Knowledge base
 Index