FAQ&KB home Search Mechatronics home Send Feedback Print

Liquid flowing back to the rinse bottle or cubitainer (FAQ)

Symptom :

Liquid flowing back to the rinse or saline container

Hint :

Check the condition of the peristaltic pump tubes.
They may be wrong sized, leaking, old, or worn out.
(replace once a month or after 7500 samples, 3000 for Starrsed Compact Standalone)

Attention:The wider bore tube is for the rinse pump. The narrower bore tube is for the saline pump

Additional information :

Peristaltic pump tubes replacement (WI-162 Peristaltic pump tube replacements)

Applicable for:

Interrliner
Starrsed RS
Starrsed TL

FAQ 30002

Related FAQ's

Very small air bubbles enter the pipette during aspiration (FAQ)

One air bubble in the pipette (FAQ)

Air bubbles entering the pipette during aspiration (FAQ)

One air bubble about 5mm under meniscus (FAQ)

Waste pump slows down and stops after 1 minute (FAQ)

First pipette is not washed sufficiently (FAQ)

Liquid dripping from needle (FAQ)

Rinse solution is not primed through system (FAQ)

Position error E18 (FAQ)

Fill nozzle does not engage with pipette (FAQ)

Fill-nozzle not functioning (FAQ)

Container "empty" not detected on Waste container (FAQ)

Pipette looks like a zebra crossing (FAQ)

Sample is not or only partially aspirated (FAQ)

Waste pump tube not functioning correctly (FAQ)

Zebra striping(FAQ)

ESR unit does not accept any ESR from LAB host computer (FAQ)

Carousel moves three position steps (FAQ)

ow to handle samples if the barcode is not read correct ?

To top of page Mechatronics home Send Feedback Print