Manual home Send Feedback Print

Previous Topic

Next Topic

Book Contents

Book Index

Led status of the four stages

Since January 2005 there are two type of fill nozzle motor assembles.

In instruments build before January 2005 and using the fill nozzle motor assembly (ESRI039205) the correct LED sequence is a critical adjustment.

 

Click here to read more about this nozzle unit adjustment.

 

old_fillnozzle_assambly_small

In instruments build after January 2005 and using the fill nozzle motor assembly (ESRI039308/311) the correct LED sequence is no longer a critical adjustment.

 

Click here to read more about this nozzle unit adjustment.

new_fillnozzle_drive_assemby

In instruments using the fill nozzle motor assembly (ESRI039324) the correct LED sequence is no longer a critical adjustment.

 

Click here to read more about this nozzle unit adjustment.

fillnozzle_drive_assemby_ESRI039324.gif

Return to Sensor adjustment (nozzle)

In This Section

Nozzle unit adjustment Version 1 (ESRI039205)

Help to make the correct sensor adjustment

Block diagrams over adjusting the fill nozzle

If the correct setting cannot be reached

See Also

Fill Nozzle adjustment

Fill Nozzle sequence

Nozzle unit adjustment Nozzle drive Version 3 (ESRI039311)

CPU chip

Rinse nozzle (wash station) alignment errors
To top of page Mechatronics home Send Feedback Print