General / Barcode screen

This menu has all the functions related to the following items.

1. General screen (General / Barcode screen, General / Barcode screen)
2. Elevator screen (Elevator screen, Elevator screen)
3. Indexer screen (Indexer screen, Indexer screen)

The following can be set and tested:

1. Hood safeguard.
   • Switch safeguard alarm ON or OFF.
     If switched OFF:
     After closing the service mode, the Hood safety guard is automatically changed to "ON" again.
2. Read Rack Number
   • Only applicable when Sysmex racks and a Sysmex protocol are used.
     Option for reading the rack number with the barcode reader. The rack number is shown on the Display rack history (Display rack history, Display rack history) screen.
     To be able to handle tube labels without check digit and rack labels (always with check digit), reading or ignoring the check digit can be set ON or OFF with Inspect check digit & Remove check digit. If the check digit settings on the barcode reader are not activated, rack labels (with a check digit) can be handled with this option.
     
3. Reset
   • Reset the Indexer and the elevator.
     
4. Barcode manipulator.
   • Barcode manipulator to the Up position.
   • Barcode manipulator to the Down position.
     
5. Barcode Rotate motor
   • Barcode motor Stop turning.
   • Barcode motor turns Left.
   • Barcode motor turns Right.
     
6. Barcode reader.
   • Shows the Barcode which is read.
   • Read barcode. For testing the barcode reader.