Start new measurement

After a measurement has completed and the report is printed (yes/no)

• Press the <Yes> for printed report.
• Press the <No> if no printed report is required.

Screen Rinse gradient system appears:

1. Open the hood.
2. Remove empty sample tube.
3. Place tube with demi-water (+/- 2,5 ml).
4. Press <Rinse>. to rinse the system.
   Screen Empty cup appears.
   
   
   Press <Clean>
5. Remove the empty (rinse) tube from under the needle.
   
6. Press OK and the Osmoscan screen appears.
7. Press <F1> or click on New...F1 to perform another Osmoscan.
   it is not necessary to dry the bob and cup between Osmoscan runs.
   or
   Press <main menu> to perform other tests.
   or if no more runs will be made that day, exit the software and perform an “End of day wash”.

Return to Osmoscan screen or Osmoscan result screen.