Mechatronics home Send Feedback Print

Previous Topic

Next Topic

Book Contents

Book Index

Powering up

  • Switch ON the LoRRca.
  • Switch ON the PC and printer.
  • Start LoRRca software.


Steady state

After switching on, the LoRRca MaxSis needs 5 minutes to warm up.

Settings Close program

See Also

General operation procedure

Preparations

Performing Osmoscan

Performing Deformability curve test

Performing Cell stability test

Performing Cell membrane stability test

Performing RBC Aggregation test

End of day wash

Powering down

Decontamination procedures Routine

Waste container disposal
To top of page Mechatronics home Send Feedback Print