Explain Numerical input

The following numerical inputs can be made:

1. Temperature in Celsius. To set the correct room temperature.
2. ESR sedimentation time in minutes. To set the correct sedimentation time: 30 or 60 minutes. This time is reset to default when Service mode is switched OFF.
3. Pipette wash time (sec) in seconds. Default value 7. This setting is reset to default when Service mode is switched OFF.
4. Pipette dry time (sec) in seconds. Default value 5. This setting is reset to default when Service mode is switched OFF.
5. Sample probe depth in millimeters.

Return to General settings (General settings, General settings) screen.