Explain ON and OFF selection
The following selections can be switched ON or OFF:
- ON: ESR's are measured after 30 minutes.
- OFF: ESR's are measured after 60 minutes.
- ON: Samples are presented in EDTA sample tubes. The samples are diluted in the Starrsed.
- OFF: Samples are presented in pre-diluted CITRATE sample tubes. Dilution on the Starrsed is switched OFF.
- ON: A temperature corrected value for the ESR is shown besides the actual measured value.
- OFF: Only the actual measured ESR value is shown.
- ON: It is not possible to run the same sample ID as long as this ID is in the pipette carousel data buffer.
- OFF: It is possible to run the same sample ID, even when it is still stored in the carousel data buffer.
- ON: If keyboard input is required, a virtual keyboard automatically pops up on the screen.
- OFF: No pop-up screen of virtual keyboard.
- This will print the measured result on a single line directly to a dot matrix printer. If this option is switched ON, it is also possible to print a new header at the top of the results.
When other printers then dot matrix are used, every result is printed on one new page.
-
- OFF: The sample probe motor will push the sample probe down to the set depth.
- ON: The sample probe motor will stop when a certain current limit is exceeded and returns to the home position.
- Reset the switch from ON to OFF and ON again.
Return to General settings (General settings, General settings, General settings)screen.
|