This option is used to set if Temperature correction is to be applied on the measured ESR results.
Use the [ ARROW DOWN ] or [ ARROW UP ] keys and select the required option.Then press [ ENTER ] to save the new setting.
Menu 5 Settings (Supervisor)
Menu 30 min. method
Menu EDTA mode
Menu Temperature
QC Settings
Menu Carousel position
Menu DST
Menu Result at limit
Menu Printer (results)
Menu Date / Time
Menu Language
Menu ESR time (min)
Menu Protocol
Menu Baudrate
Menu Checksum
Menu ACK/NACK
Menu 30 minute output