Manual control

To control assemblies separately by using the ON-OFF switch.

• Load settings is used for reloading the stored software settings.
• Save settings as is used for storing software settings to a file. There are no restrictions for the file name.
• Save settings is used for storing software settings after settings are changed or altered.

Vacuum pump:
ON the main vacuum pump is switched on.
OFF the main vacuum pump is switched off.

Waste pump:
ON the waste pump is switched on.
OFF the waste pump is switched off.
The waste pump is used for emptying the liquid separator. Do not leave this function ON as it may cause waste pump damage.

Saline pump:
ON the saline peristaltic pump is switched on.
OFF the saline peristaltic pump is switched off.
Note: If vacuum pump is OFF rinse solution will spill over the Auto rack unit

Rinse pump:
ON the pipette wash peristaltic pump is switched on.
OFF the pipette wash peristaltic pump is switched off.
Note: If vacuum pump is OFF rinse solution will spill over the Auto rack unit

All pumps OFF:
All active pumps will be switched OFF. The waste pump is switched ON for one minute.