The following Elevator settings can be made:

1. Elevator to Top position.
   • This function send the elevator to the top position.
   • The top position is set default at 75500, no need to change the default value.
2. Elevator to Fill position.
   • This function send the elevator to the fill position.
   • The fill position is set default at 64000, no need to change the default value.
3. Elevator to Home position.
   • This function send the elevator to the Home position.
4. Elevator Reset.
   • This function reset the elevator to Home position.
5. Mixer assembly test.
   • Switch ON and OFF the mixer motor.
6. Tube unit test.
   • The Forward function send the tube unit to the front.
   • The Backward function send the tube unit to the back.
7. Sample unit test.
   • The IN function move the sample arm from the home position into the needle assembly of the ESR analyser unit.
   • The OUT function move the sample arm from the needle assembly of the ESR analyser unit to the Home position.
8. Actual position shows the position of the Elevator.
   • Step LEFT: The Elevator will move in steps to the left.
   • Step RIGHT: The Elevator will move in steps to the right.

Return to Service Elevator screen (Elevator screen, Elevator screen)