Troubleshooting / Error messages

Note: Service Troubleshooting is a combination of service troubleshooting and user troubleshooting section from the user manual.

On vacuum adjustment

In case of dilution error's and the ADRC (Automatic Dilution Rate Control) is moving to the 60% the yellow orifice what is in the cross checking of flow sensor is blocked
In case of dilution error's and the ADRC is moving to the 140% there is a blockage in the needle system.
- Check the sample probe
- Mixing-piece

On position adjustment

In case of a position error alarm check the rinse position.
When not correct set the rinse position,
- run the quick belt test or
- run the flow test.

Error messages: