Check list
The laboratory supervisor should check the following instrument settings and select the required options:
- Menu - (Default is OFF)
- Menu - (Default is ON, for software versions <2.15)
- Menu - (temperature correction) (Default is ON)
|
NOTE: A small hardware modification is necessary to switch between EDTA mode and Citrate mode. See work instruction WI-405 for details. This is only possible for software versions <2.15.
|
Check the following things before each large batch of samples:
- Ensure that a chip card is present in the card reader. This may be any type of chip card.
- Open the printer and check if enough paper is available. Replace if necessary.
- Empty the waste container.
- Check the liquid levels and refill the containers if necessary.
|