Manual home Send Feedback Print

Previous Topic

Next Topic

Book Contents

Book Index

Sample tubes with barcode

  1. Start the Sample mode.
  2. Push the [ START ] key.
  3. Check that the scanned ID number appears on the display.
  4. If the ID number does not appear on the display, the barcode could not be read:
    1. Rotate the sample tube a little bit and push the [ START ] key again.
      or:
    2. Enter the ID manually as described in the next section.

Loep

NOTE:
The sampling may not start immediately if a clean pipette is not yet available, but will start automatically when a clean pipette is available within 90 sec.

To prevent the aspiration of a not properly mixed sample, sampling will not start automatically when it takes longer than 90 sec. for a pipette to become available.
The operator must then remix the sample and push the [ START ] key again.

See Also

Placing sample tubes on the needle system

Sample tubes without barcode
To top of page Mechatronics home Send Feedback Print