Appendix - Default settings Starrsed ST

Appendix - Default settings Starrsed ST

Menu text	Setting Menu	Software Default Setting	Factory Setting	Client settings
30 min. method	Lab supervisor	OFF	OFF
EDTA mode	Lab supervisor	ON	ON
Temperature	Lab supervisor	room temperature	room temperature
Set T.Corr.	Lab supervisor	ON	ON
Set DST	Lab supervisor	OFF	OFF
Set Result at limit	Lab supervisor	ON	ON
Printer (results)	Lab supervisor	ON	ON
Set system Date / TimeT	Lab supervisor	00.00.00	Time
Set system Date / Time	Lab supervisor	01-01-1998	Date
Select Language	Lab supervisor	English	English
Adjust temp. Sensor	Lab supervisor	18.3	18.3
ESR time (min)	Lab supervisor	60 Min	60 Min
Protocol	Lab supervisor	No serial output	No serial output
Set Baudrate	Lab supervisor	9600	9600
30 minute output	Lab supervisor	OFF	OFF
Checksum	Lab supervisor	OFF	OFF
ACK/NACK	Lab supervisor	OFF	OFF
Barcode reader	Service	Keyence	Keyence
Max.needle current	Service	180/100*	180/100*
Set piston position	Service	900	890

*double needle/single needle

Note: Software Default Settings are the values that are set when the software is reset by using the key board function Factory settings.