Result Printout

The results of the ESR measurements can be send to the printer. The layout of the report depends on the selection of the 60- or 30 minute method.

Columns:

1. Sample ID=Patient number.
2. Hh=Not corrected 30-minute ESR result (only in use if 30 minute mode is active).
3. ESR=Not corrected 60-minute ESR result.
4. Tc=60-minute ESR result in millimeters, corrected for 18°C. (only in use if temperature correction is active).
5. Aspect (clear, hazy).
6. Pip.=Sedimentation pipette number (number on the pipette belt).
7. Time=Actual sedimentation time in minutes.
8. T=Temperature (in degrees Centigrade).
9. Error=Error message (if the Analyzer detects an error).
10. EDTA mode.