Power up sequence
- Check all units for unblocked passageways. Racks may only be present on the pool’s stainless steel storage areas.
- Start sequence
- Switch ON the ESR analyzer unit.
- Switch ON the PC and the monitor.
- Wait until "Windows" is ready for use.
- Start the Interrliner software.
- Observe the Robotic arm movement during the start-up, after finishing the reset sequence, the ESR analyzer unit is ready for use.
- Switch ON the Interrliner. The system becomes operational when the lines "HST Version X.XX" and "Lab Comm On (or OFF)" are shown in the display.
- If applicable : switch ON the printer. The printer prints the paper header automatically.
- The Interrliner is ready for use.
|