End-of-day-wash procedure

Select the tab Maintenance and press the button End-of-day wash. A pop-up screen is shown.
Selecting Close program will stop the program immediately without running the End-of-day wash procedure.
When End-of-day wash procedure is selected, a selection screen for this function is shown.

The following options are available for this function:

1. Select from the list the desired option:
   • No End-of-day wash: The function is not active
   • Immediately: The function runs immediately after pressing OK.
   • Only once: The function runs only once at the selected time.
   • Weekdays: The function runs only on selected working days at the selected time.
   • Daily: The function runs on a daily base at the selected time.
2. Select the time of the day in hours and minutes for the selected option.

Pressing OK activates the settings.