Manual home Send Feedback Print

Previous Topic

Next Topic

Book Contents

Book Index

Separator error

If it takes too long for the waste pump to empty the waste separator, the system generates a separator error.

Separator error may be caused by:

 

Extensive foam build-up in the waste separator.

Check the separator assembly and connections for possible air leaks.

Waste-tube between waste separator and waste pump is blocked.

Replace the tube.

Waste pump failure.

Check waste pump. If the error returns, call for service.

Waste line blocked.

Check waste line.

Electrical bridge between the waste-level electrodes.

Clean waste separator, see Cleaning waste separator

See Also

Troubleshooting

General error procedure

Flushing liquids

Reagents alarm

Fill time-out error

Hazy reports

Leaking pipettes

Liquid level sensor not sensing

Sampling and results troubleshooting

Robot arm error - general procedure

Air bubbles

Quality control troubleshooting

To top of page Mechatronics home Send Feedback Print