Fill time-out error
Normally the fill sequence takes about 3 seconds. However, if the fill sequence exceeds 10 seconds, a fill time-out error will be generated. The ESR analyzer unit aborts the fill sequence and this error message will be shown on the display and reported.
Fill time-out error may be caused by:
- Blood clots or rubber debris from the tube cap in the sample.
- Check the condition of the needle.
- Filling procedure stopped by operator.
- Insufficient sample volume.
- Should be at least 1.6 ml.
- Faulty filling nozzle or filling nozzle O-ring.
- Check filling nozzle and O-ring.
- No or poor vacuum.
|