Manual home Send Feedback Print

Previous Topic

Next Topic

Book Contents

Book Index

Replacing a pipette

NOTE: Chip card type S is required !

Loep

NOTE:
Make sure that all pipettes are empty and do not need to be measured.

  • Go to Menu Service - Replace pipet.
  • Enter the number of the pipette to replace and press [ ENTER ]. The pipette is turned to the door opening.
  • Open the pipette cap and lift the pipette out. Install the new pipette in the reversed order.

    pipette_cap_open pipette_removing

See Also

Leaking pipettes

Disabling a pipette
To top of page Mechatronics home Send Feedback Print