Manual home Send Feedback Print

Previous Topic

Next Topic

Book Contents

Book Index

Data safety management

The Interrliner has its own external PC. This means that all collected data is stored on the hard-disk of the external computer.

This means that all raw data and results are kept, irrespective of a power failure or if the instrument is un-intentionally turned off. After the start-up procedure the software checks whether there are any ESR's still outstanding. If so, these will be carried out first. After a power failure the sedimentation time (60 or 30 min.) may be exceeded. However, the start time is saved and therefore the actual sedimentation time can be checked.

Important system settings are kept in an internal Flash Eprom inside the instrument.
In case of corrupted files, the program will automatically load and use the backup files.

In this chapter

Power failure

To top of page Mechatronics home Send Feedback Print