Power up sequence
- Check the In-pool, the conveyor-belt and the robotic unit for unblocked passageways. Racks may only be present on the pool’s stainless steel storage areas. Check if the Robot hood is closed.
- Start sequence:
- Switch ON the ESR analyzer unit.
- Switch ON the PC and the monitor.
- Wait until "Windows" is ready for use.
- Start the Starrsed software.
- Observe the Robotic arm movement during the start-up, after finishing the reset sequence the ESR analyzer unit is ready for use.
- Switch ON the Interrliner. The system becomes operational when the lines "HST Version X.XX" and "Lab Comm On (or OFF)" are shown in the display.
- The Interrliner is ready for use.
|